Chronological Thread 

< Chronological >      < Thread >

---

Thank you very much. This is exactly what I needed.

Best regards,
Marjan


----- Original Message -----
From: "Tuexen Michael"
<Michael.Tuexen AT icn.siemens.de>
To:
<discussion AT sctp.de>
Sent: Monday, June 18, 2001 10:07 AM
Subject: RE: [SCTP-Discussion] Running SCTP


> Dear all,
>
> the simplest way is to use only single homing.
>
> Configure one ethernet interface on host A with the
> address 192.168.1.1 and subnet mask 255.255.255.0.
>
> Configure one ethernet interface on host B with the
> address 192.168.1.2 and subnet mask 255.255.255.0.
>
> Connect these interfaces with a hub.
>
> Start on host A the discard server:
> ./discard_server -s 192.168.1.1 -V
> You must be root to do this. The -s parameter tells the discard_server
> the IP addresses it should use and the -V flags says: Be very verbose.
>
> Start on host B the terminal client:
> ./terminal -s 192.168.1.2 -d 192.168.1.1 -V
> You must also be root to run this. The -s parameter and the -V flag are
> the same as above. The -d parameter tells the terminal client to connect
> to the host with IP address 192.168.1.1. It connects (per default) to
> a discard server on the specified host.
>
> If you now type something on host B it is transmitted to host A and
> discarded. You should see corresponding output (due to the -V flag) and
> you can use Ethereal to watch the traffic.
>
> Hope this helps
> Happy SCTPing
> Michael
>
> Michael Tuexen Tel.: +49 89 722 47210
> Siemens AG Fax: +49 89 722 48212
> ICN WN CS SE 5 E-mail:
> Michael.Tuexen AT icn.siemens.de
>
> > -----Original Message-----
> > From: Marjan Bozinovski
> > [SMTP:marjanb AT cpk.auc.dk]
> > Sent: Friday, June 15, 2001 4:22 PM
> > To:
> > discussion AT sctp.de
> > Subject: [SCTP-Discussion] Running SCTP
> >
> > Hi,
> >
> > I am an SCTP beginner, and I have just installed the SCTP implementation
on two PCs which work with FreeBSD. There is a documentation, which I have
been reading, but, I still do not know how to run or start some
communication between the two PCs which are connected via hub. Please
explain me, what should I do in order to run an SCTP communication.
> >
> > Best regards,
> > Marjan Bozinovski
> _______________________________________________
> discussion mailing list
> discussion AT sctp.de
> http://www.sctp.de/mailman/listinfo/discussion
>

---

• [SCTP-Discussion] Running SCTP, Marjan Bozinovski, 06/15/2001
  • Re: [SCTP-Discussion] Running SCTP, M. Mueller, 06/16/2001
  • [SCTP-Discussion] Running SCTP, Christopher Ross, 06/18/2001
  • <Possible follow-up(s)>
  • RE: [SCTP-Discussion] Running SCTP, Tuexen Michael, 06/18/2001
    • Re: [SCTP-Discussion] Running SCTP, Marjan Bozinovski, 06/18/2001

---

Archive powered by MHonArc 2.6.19+.