Hello,
Thank you so much for the email. Could you please let
me know a little bit details? So far I know, SCTP does
not support load sharing in its current form. But I
would like to transfer data to all active paths
simultaneously using SCTP implementation provided by
www.sctp.de. And I also would like to make a
comparison of the performance (for example association
throughput) between Standard SCTP behavior(which
supports only single path data transfer; where
multihoming is used only for redundancy purpose) and
load sharing SCTP behavior(which will support
concurrent multipath transfer)? Is it possible? I am
using sctplib-1.0.1. Do I need to install new
sctplib-1.0.2 and API?
Thanks,
Babu
--- Michael Tuexen
<Michael.Tuexen AT micmac.franken.de>
wrote:
Hi Babd,___________________________________________________________
you can change the primary path whenever you want.
So there
is an API for you to do it. If you need more than
that, you
have the source code of the sctplib...
I hope this helps.
Best regards
Michael
On Jan 2, 2005, at 20:06 Uhr,
hi_research AT yahoo.co.uk
wrote:
Hello,Standard
I would like to compare the performance of
SCTP and Load Sharing SCTP. May I check thetransfer
performance of load Sharing SCTP(Multi-path
SCTP)using this SCTP implementation?
Thanks,
Babu
ALL-NEW Yahoo! Messenger - all new features - evenmore fun!
http://uk.messenger.yahoo.com
_______________________________________________
discussion mailing list
discussion AT sctp.de
http://www.sctp.de/mailman/listinfo/discussion
_______________________________________________
discussion mailing list
discussion AT sctp.de
http://www.sctp.de/mailman/listinfo/discussion
___________________________________________________________
ALL-NEW Yahoo! Messenger - all new features - even more fun! http://uk.messenger.yahoo.com
Archive powered by MHonArc 2.6.19+.